New 5Pc Watchmakers Tool Set

Watch Case Press

• This is a new watch case press with 8 dies
• This press will close all difficult watch cases and allows the right amount of pressure to not break the crystal when in recessed die tool
• It includes 8 dies that measure 14, 15, 18, 19, 24, 30, 31, and 37mm
• It measures approximately 2 5/8" x 1 1/2" x 3 11/16" (66 x 38 x 94 mm)

Bench Knife

• This is a new bench knife with a wooden handle
• This case opener will fit between the watch back and the case to pry it open
• It measures approximately 4 5/8" (117 mm) long

Spring Bar Remover

• This is a new spring bar remover
• For fitting and removing spring bars
• Features two tips: V-edged flat blade and push-pin
• Tips are stronger than conventional spring bar tools but have the same thread for interchangeability
• It measures approximately 6" (152 mm)

Suction Case Opener

• This is a new suction case opener
• The suction type case opener is great for lifting the case back off of screw-back and waterproof watches after it has been loosened
• The rubber tip will not scratch cases or crystals
• Twisting motion applies suction to the case to open it
• It measures approximately 4 7/16" (112 mm) in length

Adjustable Case Opener

• This is a new adjustable case opener
• This tool has adjustable metal teeth for use on watch case backs
• The tips adjust from 9/16" (14 mm) to 2" (50 mm)
• It measures approximately 2 3/4" x 1 1/8" (69 x 28 mm)